Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
change remote for combo board
#1
Hello! i had swapped a combo board into another tv as the board in the tv was damaged. 
i dont have a remote for the working board so is there a way use the remote from the old combo board 
on the new one?
Reply
#2
if both boards are the same then replace flash ic. and if different then change software for required remote control
Reply
#3
(10-07-2021, 08:15 AM)Azhar Kazmi Wrote: if both boards are the same then replace flash ic. and if different then change software for required remote control

ok thanks. where could i get the sotware for the remote? been searhing but no luck
Reply
#4
www.kazmielecom.com
Reply
#5
Change complete software not only for remote control
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)