Kazmi Elecom Forum

Hello! i had swapped a combo board into another tv as the board in the tv was damaged. 
i dont have a remote for the working board so is there a way use the remote from the old combo board 
on the new one?

if both boards are the same then replace flash ic. and if different then change software for required remote control

(10-07-2021, 08:15 AM)Azhar Kazmi Wrote: [ -> ]if both boards are the same then replace flash ic. and if different then change software for required remote control

ok thanks. where could i get the sotware for the remote? been searhing but no luck

Change complete software not only for remote control